A molecular fluorophore in citric acid/ethylenediamine carbon dots identified and quantified by multinuclear solid-state nuclear magnetic resonance

The composition of fluorescent polymer nanoparticles, commonly referred to as carbon dots, synthesized by microwave-assisted reaction of citric acid and ethylenediamine was investigated by ¹³C, ¹³C{¹H}, ¹H─¹³C, ¹³C{¹⁴N}, and ¹⁵N solid-state nuclear magnetic resonance (NMR) experiments. ¹³C NMR with spectral editing provided no evidence for significant condensed aromatic or diamondoid carbon phases. ¹⁵N NMR showed that the nanoparticle matrix has been polymerized by amide and some imide formation. Five small, resolved ¹³C NMR peaks, including an unusual ═CH signal at 84 ppm (¹H chemical shift of 5.8 ppm) and ═CN₂ at 155 ppm, and two distinctive ¹⁵N NMR resonances near 80 and 160 ppm proved the presence of 5-oxo-1,2,3,5-tetrahydroimidazo[1,2-a]pyridine-7-carboxylic acid (IPCA) or its derivatives. This molecular fluorophore with conjugated double bonds, formed by a double cyclization reaction of citric acid and ethylenediamine as first shown by Y. Song, B. Yang, and coworkers in 2015, accounts for the fluorescence of the carbon dots. Cross-peaks in a ¹H─¹³C HETCOR spectrum with brief ¹H spin diffusion proved that IPCA is finely dispersed in the polyamide matrix. From quantitative ¹³C and ¹⁵N NMR spectra, a high concentration (18 ± 2 wt%) of IPCA in the carbon dots was determined. A pronounced gradient in ¹³C chemical-shift perturbations and peak widths, with the broadest lines near the COO group of IPCA, indicated at least partial transformation of the carboxylic acid of IPCA by amide or ester formation.     

FeOOH@Metal–Organic Framework Core–Satellite Nanocomposites for the Serum Metabolic Fingerprinting of Gynecological Cancers

High-throughput metabolic analysis is of significance in diagnostics, while tedious sample pretreatment has largely hindered its clinic application. Herein, we designed FeOOH@ZIF-8 composites with enhanced ionization efficiency and size-exclusion effect for laser desorption/ionization mass spectrometry (LDI-MS)-based metabolic diagnosis of gynecological cancers. The FeOOH@ZIF-8-assisted LDI-MS achieved rapid, sensitive, and selective metabolic fingerprints of the native serum without any enrichment or purification. Further analysis of extracted serum metabolic fingerprints successfully discriminated patients with gynecological cancers (GCs) from healthy controls and also differentiated three major subtypes of GCs. Given the low cost, high-throughput, and easy operation, our approach brings a new dimension to disease analysis and classification.     

Microelectromechanical Systems for Nanomechanical Testing: Electrostatic Actuation and Capacitive Sensing for High-Strain-Rate Testing

Experimental Mechanics - There have been relatively few studies on mechanical properties of nanomaterials under high strain rates, mainly due to the lack of capable nanomechanical testing devices....     

超空泡射弹水下侵彻靶板三相耦合数值模拟

超空泡射弹侵彻问题的实质是特殊水下结构受到高速冲击载荷作用下的动态响应。对12.7 mm口径超空泡射弹侵彻典型水下目标壳体的毁伤效果开展研究,基于LS-DYNA有限元分析软件建立水环境中超空泡射弹垂直侵彻曲面靶板的等效模型,探讨射弹侵彻过程中动能侵彻和气泡溃灭对靶板联合毁伤效果,获得了靶板在各阶段的应力变化和结构变形规律。结果表明:侵彻靶板前,射弹着靶速度为200 m/s时的头部表面水介质压力峰值达768 N,靶板表面有明显下凹变形;侵彻靶板时,伴随着射弹动能侵彻和气泡溃灭冲击,水介质造成的影响不足动能侵彻的2%;侵彻靶板后,在靶板正面形成峰值速度为42 m/s的水射流进一步作用于破口;靶板整体弯曲变形,在200~300 m/s范围内,随着射弹着靶速度的增加,靶板弯曲形变量减小;靶板局部发生延性穿孔,射弹在水环境中具有更好的破口效果,射弹速度变化对破口尺寸影响不大。     

传输线方程的高精度龙格−库塔数值求解方法

提出了一种求解传输线方程的高精度龙格-库塔(RK)方法。此方法在空间上采取高阶泰勒展开,提高了对空间微分的近似精度,减少了数值色散所带来的误差。与传统的时域有限差分法(FDTD)方法相比,在每波长采样数相同时,RK方法的计算精度更高。同时,根据Taylor模型,对外界平面波激励源进行离散,成功利用RK方法对外部场激励传输线进行求解,扩大了龙格-库塔方法在求解传输线方程时的应用范围。通过编程对平面波辐照下无限大地平面上的单导体与双导体的算例分别应用FDTD方法与RK方法进行了计算,验证了RK方法的正确性。结果表明同等计算条件下RK方法的计算精度更高。     

基于混合空穴注入层的湿法制备高效蓝光热激活延迟有机发光二极管

在溶液法制备有机电致发光器件(OLEDs)的研究中, PEDOT∶PSS由于具有较好的成膜性与高透光性而常被用作器件的空穴注入层。但相关研究表明, PEDOT∶PSS本身稳定性较差以及功函数较低,这使得溶液法制备OLEDs的性能差且不稳定。蓝色作为全彩色的三基色之一,制备高效的蓝光器件对于实现高质量显示器件和固态照明装置必不可少。而目前溶液法制备蓝光OLEDs的器件效率普遍较差,针对此问题,本文利用传统的蓝光热激活延迟荧光发光(TADF)材料DMAC-DPS作为发光层,用溶液法制备了蓝光TADF OLEDs,通过在PEDOT∶PSS中掺杂PSS-Na制备混合空穴注入层(mix-HIL)来提高空穴注入层的功函数,研究其对于蓝光TADF OLEDs器件性能的影响。首先在PEDOT∶PSS水溶液中掺入不同体积的PSS-Na溶液,在相同条件下旋涂制膜,进行器件制备。通过观测各个实验组器件的电致发光(EL)光谱,发现掺入PSS-Na后器件EL谱存在光谱蓝移的现象,这是由于掺入PSS-Na水溶液后, mix-HIL层的厚度有所降低,使得在微腔效应作用下, EL光谱发生蓝移。通过对比各组器件的电流密度-电压-亮度(J-V-L)曲线及其计算所得器件的电流效率,结果显示随着PSS-Na的掺入,器件的亮度和电流都有所增大,器件的电流效率也得到了提升,当掺杂比例为0.5∶0.5(PEDOT∶PSS/PSS-Na)时提升幅度最大(亮度提升86.7%,电流效率提升34.3%)。通过在瞬态电致发光测试过程中施加或撤去驱动电压观测了器件EL强度的变化,分析了在混合空穴注入层/发光层(mix-HIL/EML)界面处的电荷积累情况。实验证明,通过在PEDOT∶PSS中掺杂PSS-Na制备mix-HIL获得了蓝光TADF OLEDs器件性能的提升,这是一个获得高效率溶液法制备OLEDs的可行方法。     

油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

Variation in essential oil content and composition of Ridolfia segetum Moris based on 30-hour prolonged fractionated extraction procedure

Abstract

A comprehensive study on essential oil samples extracted from Ridolfia segetum Moris (Apiaceae) collected in Tarquinia (Italy) is reported. In this study, a 30-hour, fractionated, steam distillation procedure for essential oil preparation was applied. The gas chromatographic-mass spectrometry analysis showed monoterpene o-cymene and phenylpropanoid dill-apiol as the major essential oil’s constituents revealing a new chemotype dependent on extraction duration. Great impact of the duration of the distillation process on chemical profile of essential oil was observed; prolonged distillation gives chemically more diverse essential oil samples. Preliminary microbiological evaluations of the essential oils samples revealed some activity, although not high, against Candida albicans.     

Water-induced formation of an alkali-ion dimer in cryptomelane nanorods

Tunneled metal oxides such as α-Mn₈O₁₆ (hollandite) have proven to be compelling candidates for charge-storage materials in high-density batteries. In particular, the tunnels can support one-dimensional chains of K⁺ ions (which act as structure-stabilizing dopants) and H₂O molecules, as these chains are favored by strong H-bonds and electrostatic interactions. In this work, we examine the role of water molecules in enhancing the stability of K⁺-doped α-Mn₈O₁₆ (cryptomelane). The combined experimental and theoretical analyses show that for high enough concentrations of water and tunnel-ions, H₂O displaces K⁺ ions from their natural binding sites. This displacement becomes energetically favorable due to the formation of K²⁺ dimers, thereby modifying the stoichiometric charge of the system. These findings have potentially significant technological implications for the consideration of cryptomelane as a Li⁺/Na⁺ battery electrode. Our work establishes the functional role of water in altering the energetics and structural properties of cryptomelane, an observation that has frequently been overlooked in previous studies.

Water displaces potassium ions and initiates the formation of a homonuclear dimer ion (K²⁺) in the tunnels of hollandite.     

The Influence of N,N-Dimethylformamide on Dispersion of Multi-Walled Carbon Nanotubes

Russian Journal of Physical Chemistry A - Preparation of highly homogeneous disperse ions multi-walled carbon nanotubes (MWCNTs) has vital effect on their applications. In this research, the...